1981 Chevy C10 Recalls

OCT 05, 1981

1981 CHEVROLET C10

THE SPARE WHEEL IS ONE INCH WIDER THAN THE MAXIMUM APPROVED RIM WIDTH AND FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS".



THE SPARE WHEEL ASSEMBLY WILL BE REPLACED WITHOUT CHARGE TO OWNER.

253

GENERAL MOTORS CORP.

DEC 14, 1981

1981 CHEVROLET C10

THE HYDRAULIC BRAKE FLUID USED IN CERTAIN VEHICLES MAY FAIL TO COMPLY WITH THE BRAKE FLUID BOILING POINT REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 116, "MOTOR VEHICLE BRAKE FLUIDS". BRAKING EFFICIENCY MAY BE REDUCED AND VEHICLE STOPPING DISTANCE INCREASED, ESPECIALLY WHEN HARD OR FREQUENT BRAKING RAISES BRAKE FLUID TEMPERATURE.



SUSPECT HYDRAULIC BRAKE FLUID WILL BE BLED FROM THE BRAKE SYSTEM AND REPLACED WITH GM DELCO SUPREME NO. 11 OR AN EQUIVALENT, WITHOUT CHARGE.

17

GENERAL MOTORS CORP.

OCT 24, 2007

1981 CHEVROLET C10

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

121680

HONEYWELL INTERNATIONAL, INC.